Aquabot Robotic In-ground Pool Cleaner

In stock
73% of 100
  • #1 Best Seller!
  • Climbs & cleans walls.
  • Built-in filter system.
Was $776.67
In stock
Next Day Delivery Next Day
This item will arrive on the next business day for orders placed by 4 pm local time with the exceptions of 2 pm for the Florida, 2:30 pm for the Texas and 3 pm for the Tennessee warehouses.
Ground Delivery Ground
Your current location is outside the Next Day Delivery area. This item ships UPS Ground and usually arrives in 2 to 3 business days.

The Aquabot In-Ground Robotic Cleaner will get the job done right. It can clean and filter any sized pool and/or pool surface. The only surface exception is tile. The Classic boasts an impressive pool to wall transition at 90 degrees so no matter what height your pool rests at, it will make it so there is no leaf unturned throughout the cleaning process. The easy to clean filter bags can trap particles up to (2 microns). With fixed and sturdy scrubbing brushes your pool will be sparkling clean and healthy in no time. Your pool guests wont be waiting long while the Classic filters your pool water to pristine conditions.

For Technical support on Aquabot In-ground Robotic Pool Cleaner, please contact Aqua Products at 1-800-221-1750

  • Electrical Requirements:120VAC/60Hz
  • Power Consumption:230W
  • Dimensions:17" X 14 1/2" X 11 1/8"
  • Weight:19 lbs
  • Cable Length:50'
  • For In-Ground Pools
  • Shape:Rectangle, Lap, Kidney, L-Shape, Round, Oval
  • Surfaces:Vinyl, Gunite/Concrete, Fiberglass
  • Pool to Wall Transition:90 Degree Angle
  • 1 year warranty
Helpful Tips & Useful Information:

  • IMPORTANT: Alternate the diagonal locked position of the Floating Handle with each use of your cleaner! This will help reduce possible twisting of your Floating Cable and enable cleaning of any areas missed during the prior cleaning cycle!

  • Cleaner Start Position: Holding the Floating Handle, submerge your cleaner upside down, and gently rock it back and forth under the water to allow any trapped air to escape, which is critical for proper balancing or it may not clean and cover your pool as designed.

    While submerged turn upright, then let go allowing your cleaner to settle to a level area on the pool floor near the shallow end. Starting it on an inkling (like a deep end hopper) may cause the cleaner, program and sensors to mistakenly consider the incline as the floor, and conversely on the floor as the wall. This would offset its cleaning program and coverage, resulting in missed areas. Be sure to start the cleaner on a level surface every time.

    Turn ON Power Supply to begin cleaning.

  • Scrubbing Brushes Care and Replacement: Your cleaners Scrubbing Brushes provide traction and give it the ability to loosen debris. It is important that you not let the Brushes get worn down otherwise your cleaner may lose the ability to scrub, climb, turn and move to clean and cover all areas of the pool. Eventually you will need to change the Brushes on your cleaner. When they need replacement will depend upon how often you use your cleaner and upon the conditions of your pool. High chemical concentrations and rough surfaces will cause faster Brush wear. We recommend that you inspect Brushes frequently to check for excessive wear.

    The Molded Rubber Brushes that come standard on most cleaner models will function well on most any surface (including concrete, plaster, gunite, vinyl and pebble). The Super Brushes will work on virtually all surfaces other than highly polished tile. Foam Brushes are recommended for fiberglass and vinyl surfaces only. PVA Brushes are recommended for fiberglass, vinyl and highly polished tile.

  • Write Your Own Review