Doheny's Pool Pro Economical Cleaners Manual for sku 7824 and 7825

FAST START-UP, SAFELY OPERATE AND EFFICIENTLY CLEAN! To prevent potential injury and to avoid unnecessary service calls, read this manual carefully and completely.

SAVE THIS INSTRUCTION MANUAL Use of unauthorized replacement parts voids warranty. ATTENTION INSTALLER – THIS MANUAL CONTAINS IMPORTANT INFORMATION ABOUT BE PROVIDED TO THE END USER OF THIS PRODUCT. FAILURE TO READ AND FOLLOW ALL INSTRUCTIONS COULD RESULT IN SERIOUS INJURY.

SAFETY INSTRUCTIONS - READ PRIOR TO USE.

SUCTION HAZARD - When using the pool cleaner, keep it away from body parts when the cleaner is connected to suction.

CHILD DROWNING RISK - Adult use only. Never allow children to use the pool cleaner. Do not allow swimmers in the pool during cleaner operation. Store out of reach of children.

Preparing Your Pool
Assembling & Installing Your Pool Cleaner
Step 1: Check Contents
Step 2: Assemble the Pool Cleaner
Step 3: Use of the Deflector Wheel
Step 4a: Connect Hose
Step 4b: Position Hose Weight
Step 5: Flow Control Valve
Troubleshooting

Problem: Pool cleaner does not move or moves slowly

  • Make sure the main drain is closed
  • Check the flow control valve and make sure the flow to pool cleaner is sufficient
  • Check diaphragm for wear or damage
  • Backwash filter and empty pump strainer basket

Problem: Pool cleaner gets stuck at steps or in a corner

  • Fit deflector wheel
  • Make sure total hose length is correct
  • Adjust return line eyeball fittings to use the water flow to help guide away from the steps or corner

Problem: Pool cleaner moves in a repetitive, non-random pattern

  • Make sure return line fittings are directed downwards
  • Check that the hose weight position is correct
  • Make sure total hose length is correct

Problem: Pool cleaner stays in only one end of the pool

  • Check the return line flow and redirect if necessary
  • Check the total hose length and add more hose if necessary
  • Check that hose weight position is correct

Problem: air bubbles can be seen in the flow from the return line

  • Check the hose to ensure there are no leaks
  • Check the connection of the flow control valve, to make sure it is under water at all times
  • Check the pump basket lid is fitted correctly, is not loose or cracked and that no o-rings are worn or missing. If necessary, contact your pool professional for assistance.

Problem: pool cleaner falls on its side

  • Make sure the outer extension pipe swivels freely

Problem: hose won't fit flow control valve

  • Fit hose adaptor to flow control valve1
Routine Maintenance
When removed from the pool, make sure the hose is straight. Never coil the hose as this may cause distortion which may adversely effect the pool cleaner.
Remove the pool cleaner (including hose) before chemical treatment. Wait a minimum of 4 hours after super chlorination (shock treatment) of your pool before re-installing the pool cleaner.
Clean the filter skimmer basket and pump basket regularly.
When not in use, keep the cleaner disc flat to aviod risk or warping.
Periodically inspect your pool cleaner for signs of wear. If necessary, replace any worn parts.
NOTE: Due to harsh conditions in which your cleaner operates, it’s colors may fade and discolor over time.
Replacing the Diaphragm
The diaphragm of your pool cleaner operates at the rate of approximately 360 beats per minute. In the event that it does become worn or damaged and needs to be replaced, somply follow these easy steps:
To install a new diaphragm, simply reverse the process
Download